Esse Junglas Mods Part 3 May 25, 2023 / seratbushcraft / 1 Comment Too wet today to work on my van, decided to do some knife work instead and stripped the Esse Junglas, ready to patina. handle off ready to paint strip after paint removed and scrapped still left a grey finish that required a scotch brite wheel belt to remove showing the difference between the finishes scotch brite belt fully stripped ready to dip ferric acid bath first followed by coffee dip finished piece sitting on an unfinished Huon Pine coffee table. May give it another dip as yet but its a user. Cutting Tools Previous post Setting Up New Rapid Ridge-line System Next post Van Build Part 3 Stage 1 Insulation 1 Comment Brenton Hann June 1, 2023 at 3:35 am I have sand blasted a few blades and it gives very decent shark skin non-stick finish. just do the edge honing about 5 to 6mm. Leave a ReplyYour email address will not be published. Required fields are marked *Comment * Name * Email * Website Save my name, email, and website in this browser for the next time I comment.